TDT Racing

About time to start posting again.

Quick little expansion loom for an Evo 9 wagon for equipped with a PnP. This loom consists of oil, fuel pressure, air temp, CAN supply for the Wideband controller and a spare “extras “ connector for the left over I/O, adding a spare I/O connector is very handy when dealing with PnP ecus due to having to disassemble the ecu housing to add extra inputs or outputs to the board, so populating it in the loom allows for future expansion with ease.

As always, tefzel sheathed in raychem DR25, even for street cars.

___________________________________________________________________

➡️➡️➡️➡️

Recently pulled together this Custom harness for a EJ257 swapped SH Forester , 100% of this swap is from a GR STI, everything from the main body loom, cluster, seats, centre console etc. so it was only fitting to create a new engine loom for the engine setup.

This loom consists of retaining the factory 54 Pin disconnect, TGV and EGR delete, addition of a wideband and some additional temp and pressure sensors.

This engine will be paired up with a which was more suiting for the application vs the standard PnP ecu link offers. Especially for the built in Wideband controller on the FuryX

Will post more once it’s installed with the fresh brand new crate block from Subaru.

____________________________________________________________

David had his Datsun 280z project dropped off for us to finish before spring, this thing is sick! Full s15 Sr20 swap with a 6speed! Along with a PILE of new parts for install, this car should keep us plenty busy! We’ve already made a huge dent that will be posted very shortly.

🏎:
📸:

_________________________________________